AirDog Raptor RP 4G 100GPH Lift Pump (2011-2014)

AirDog Raptor RP 4G 100GPH Lift Pump.

This is the Raptor-4G RP-100 fuel system for the 2011-2014 6.6L Duramax. This system mounts to the frame jig in front of the fuel tank for a clean looking installation. The suction line connects to the factory suction fitting on top of the fuel module. The pressure side connects to the factory injection pump feed line on the frame. These pumps are internally regulated and do not require a return line. This is a 100GPH (Gallon Per Hour) fuel system for stock fuel trucks.

The Duramax is probably the most responsive to an aftermarket lift pump. The GMC and Chevy Duramax pick-up trucks do NOT have a lift pump to supply fuel to the engine. From the factory, the CP3 injection pump is the truck's only means of getting fuel from the tank to the engine. If you were to look at our video of “How the AirDog works” it will show you what happens when the CP3 pump pulls fuel from the tank to the engine. Therefore because the fuel is under constant suction it causes cavitation and excessive wear and tear on injectors and your injection pump. Also, this is the #1 cause of low rail pressure codes when adding aftermarket programmers or tuners that increase the demand for fuel. By providing both constant positive fuel pressure and 100% pure fuel to the engine, is where you get the added benefits of smoother and quieter idle, better throttle response, increased fuel economy, better mid-range through top end power and more consistent rail pressure to support both stock and modified engines.

The AirDog Raptor is preset from the factory at 8-10PSI. Utilizing the new 4G technology, it provides a quiet, smooth, and steady fuel supply that assures maximum performance.

Features:

•4G Technology (4 bearing Motor design, Intermediate shaft)
•Built-in Adjustable Regulator(preset at 8-10PSI)
•No Return Line Needed
•Single-piece Pump Body
•Gerotor Pump
•Flow Rate of 100 GPH
•Easy Installation