Home - Dodge Cummins - 2003-2004 24 Valve, 5.9L Early - Engine - Components
Click on image to zoom

Hamilton Cams, Dodge/Cummins Daily Driver/Mid-Range Camshaft, Steel (1998.5-2018) 5.9L/6.7L

07-c-188/220S
Fits: 1998.5-2018 Dodge/Cummins
Pricing: $699.00
Qty:

Description

Information:
•RPM Range: 1700-4000
•Drops EGT 200-300
•Increased Mid Range power
•Duration at .050? of lift 188 Intake, 220 Exhaust
•This is the Steel Version of our 188/220



Modification Required:
•For it to be “drop in” on a 12v you will need no more than .025? piston protrusion and at least .055? valve face depth with a standard head gasket and a 99 intake centerline. On a 98 – 02 24v you will need no more than .025? piston protrusion and at least .038? valve face depth with a standard gasket. On an 03 and up, it needs .018?piston protrusion and at least .038? valve face depth with a standard gasket. If you do not meet the minimum requirements for piston to valve clearance, don’t worry, you can still run an oversize head gasket or cut valve reliefs.
•Although this is considered a drop in cam it is important to check clearances (You can use our clearance calculator to make it a little easier)
•For the Steel version you will need at least two bushings installed in the cam tunnel, otherwise the steel could eat into the cast iron block
•We always recommend new lifters when changing a cam.



Applications:
•Used in daily drivers
•Larger single, or set of compounds
•Weekend warrior
•Drag strip
•Stock class pulling




Applications:
•Used in daily drivers
•Larger single, or set of compounds
•Weekend warrior
•Drag strip
•Stock class pulling



Break in:

To make sure that you have no issues during break-in, follow these few suggestions.
•Make sure that the cam has a Liberal amount of quality assembly lube applied
•DO NOT let the engine start without oil pressure
•When this is a new engine, be sure to put a liberal amount of assembly lube in the oil pump and prime the oil filter
•Be sure to change the oil after you have done your break-in procedure. When the filter and oil system are already primed, engine will get oil pressure much faster than if the oil is changed at the same time.
•Disconnect the fuel system and spin the engine with the starter until oil pressure can be read or until oil is coming out of the rocker arms.
•Do not let the starter run for more than 10 seconds at a time
•Once oil pressure has been verified, let the engine start and run for five minutes at 1200-1500rpm then shut engine down
•Adjust valves then you are cleared to abuse your engine. Enjoy the added airflow
•if you need to re-torque or “hot-torque “the head, do so before adjusting valves. Re-torqueing the head changes the valve lash setting, so it is important to set lash last.

Details

  • 07-c-188/220S
  • 07-c-188/220S
  • Hamilton Cams
  • New

Shipping Information

  • Item Requires Shipping
  • 10.0 lbs.
  • W8.0000” x H8.0000” x L36.0000”

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.